how to make a 3D light box

Any house or business would benefit from having one, and it would be a great birthday or wedding gift. In order to fully appreciate its beautiful design, you can either hang it on the wall or place it on a desk. Another way to explain it is that this light box is made up of paper cutouts that have been placed on top of each other in a glass box. LED lights are placed behind each layer, resulting in a three-dimensional appearance. It is my intention in this video to take you through the processes I took to make this light box and to offer you with some ideas on how to achieve the similar effect on your own.

Create your own or use a template to get started.

So, the first step is to download and print the template, which is the first step. It may, however, be adjusted up or down to accommodate any light box that is 8 by 10 inches in size (20 by 25 centimetres). In addition, you could come up with something really unique.

For this project, it is advised that you use 170 grammes of white cardstock, which is both robust and thin enough to allow for light to pass through.

Draw the first layer of your design on the card paper, and then draw a 1 cm border around each layer to make it more visually appealing. It will be much easier to connect the layers as a result of this. Nothing is ever going to happen in this place. Please visit LightboxGoodman for more info.

Remove any extra layers by trimming them.

You may remove the first layer using an X-Acto knife after you’ve completed the first layer with it. The X-acto knife is a unique cutting equipment that allows you to make the most accurate and sharpest cuts possible on your projects.

After that, move the first layer to a new piece of card stock and create the second layer from there. After removing the first layer, apply the second coat and finish it. After all of the layers have been sliced, go through the process again for each one.

The Moon and the Night Sky

On the last layer, a massive moon and stars were generated, which I then painted over top of. I carved out a circle for the moon with a utility knife and poked holes in a piece of foam board for the stars with a pin using these tools.

Apply glue to the surfaces.

Spacers made of foam are sandwiched between each of the layers to make the reassembling process easier. A three-dimensional appearance and a sensation of depth are created as a consequence of this technique. It is now possible to remove the foam spacers. They are all the same height and breadth. It was my first time creating spacers, and I built 12 spacers that were 25 cm in length and 12 spacers that were 18 cm long. There should be four spacers between each layer. After that, use a strong glue to bind all of the parts together. The second layer should be placed on top of the first layer once the first has been glued in place. Ensure that the layers are properly aligned. Continue until all of the layers have been linked together successfully.

Read more interesting articles at Secrecyfilm